Video-mount-products LCD-1CW Manuel d'utilisateur télécharger pdf (Page 3)

Step 1

Before starting, lay out all parts to your mount and match them to

the parts list provided. Verify that you have all your parts before

attempting to assemble the mount.

Step 2

Attach the mounting plate to the LCD using the M4 or M5

screws.

Step 3

Mark the ceiling or desired mounting surface in preparation of in-

stallation of ceiling plate . If mounting to wooden ceiling joists,

pre drill pilot holes using a 7/32” drill bit. Attach the ceiling plate

to the wooden ceiling joist using the 5/16” by 2.5” long lag screw

and washer . WARNING: Please verify that your mounting

surface will support the combined weight of your mount, mount-

ing hardware, and ﬂ at panel. Also verify that the mounting sur-

face is safe to drill through. Please note only mounting hardware

for mounting to wooden ceiling joists will be provided with the unit.

If mounting to a surface other than wooden ceiling joists then other

hardware will be required. If in doubt or uncertain about any of the

above, please contact a professional installer.

Step 4

Attach the swivel bracket assembly from step 2 to the support tube

using the 3/8” screw , washers and nylon nut . Insert

adjustable screw into the back of the swivel bracket for

use when tilting the monitor.

Step 2: Attaching the mounting

plate to the LCD

Step 3: Attaching the ceiling

plate to the ceiling

Step 4: Attaching the swivel

bracket to the support tube

1 2 3 4

Pas de commentaire

Video-mount-products LCD-1CW Manuel d'utilisateur Page 3