Video-mount-products PDS-LCHB Manuel d'utilisateur télécharger pdf (Page 4)

Step 5

Secure the Mounting Rails (#4 or #35) to the H Bracket (#3) using

the 5/16” Screws (#16) and Washers (#15).

Step 6

Screw the 1.5” NPT into the Pipe Couple (#10) as tight as pos-

sible. Once the Pipe Couple (#10) is securely tighten screw the

¼”-20UNC brake screw in the threaded hole in the side of the Pipe

Couple (#4) as tight as possible.

Step 7

Lift the H Bracket (#3) onto the tabs of the Tilt Bracket (#2).

Once the H Bracket (#3) is set onto the Tilt Bracket (#2), secure

the two together using the M5 Security Screws (#5) in the holes

at the bottom of the H Bracket and Tilt Bracket.

Please verify that all nuts and screws are securely tightened.

Step 5: Securing the mounting

rails to the H bracket

Step 6: Attaching the pipe

couple to the 1.5” NPT mast

(mast not provided)

Step 7: Attaching the H bracket

onto the tilt bracket

1516

WARNING: The installer of these products must verify that the mount surface, ceiling or wall, will safely

support the combined weight of all attached equipment and hardware. Video Mount Products will not

be held liable for the improper use or installation of its products.

Enjoy Your Mount!

1 2 3 4

Pas de commentaire

Video-mount-products PDS-LCHB Manuel d'utilisateur Page 4